Floor tiles usually should be laid over a strong underlayment of cement board or treated plywood.
Tile over hardwood subfloor.
If the tile is being installed in a bathroom consider applying an isolation membrane over your wood subfloor to further protect against expansion and contraction.
How to tile on a wooden floor 1.
However if it s still somewhat rough bumpy or.
Check for dips in the floor by sliding a 4 foot to 6 foot straight edge in different directions all around the room.
Use intervening layers of two sheets of plywood.
According to backer board manufacturers and tile setters installing backer board directly over an old solid wood subfloor is risky for a couple of reasons.
Fill seams in the subfloor with caulk.
Tape off any affected vents with painter s tape.
A 3 4 inch plywood subfloor on a joist structure with 24 inch spacing needs the extra thickness of cementboard or the floor will flex and the tiles will crack.
Measure the wall.
Roll on a layer of latex primer sealer.
Second the strength of wood boards isn t always consistent.
Install 1 4 inch cork by thin setting it to the concrete pad then installing the heating system by fastening it to.
Uncoupling membranes aren t recommended for tiles smaller than 2 inches square and should not be used when covering old hardwood flooring due to adhesion problems.
How to install vinyl tiles over a wood floor sand the wood floor make sure it s thoroughly clean and dry until it s as smooth and even as possible with no bumps.
This prepares and seals the surface for the.
Still you may need to tile directly over an existing hardwood floor for instance to avoid raising the floor level significantly relative to an adjacent floor.
If your wood subfloor is smooth and even you can progress to step 3.
Apply fiberglass tape to each seam in the backerboard to cover it.
Trowel on a thin layer of thinset mortar over the.
Lay down a vapour barrier overtop the concrete pad then fasten 3 4 inch plywood using a ramset to the concrete pad.
While tile can be laid on plywood do not install tile directly onto the plywood subfloor itself.
If installing over an appropriate wood surface sand the wood to make it smoother and remember that the installation will work better over a subfloor at least 1 1 8 inches thick.
You shouldn t tile directly over hardwood flooring since it can expand contract and cup due to seasonal changes in temperature and humidity.
Use thinset with a higher latex content thinset is the wet base that you first trowel on the plywood to make the tile stick.
Lay down 1 2 inch thick cement backerboard over the wood subfloor or hardwood.
First changes in humidity make solid wood shrink swell and cup more than plywood.
If so make sure the floor is solid and well sealed.