Give the screw a clockwise turn and test to see whether the door slides easier.
Tilt and slide doors falling off.
Roll the door toward the latch side jamb then turn the adjustment screws until the door is parallel with the jamb.
You may also want to check out our step by step guideto adjusting your sliding doors.
Sometimes one roller falls out of the track and the bottom edge of the door skids along the lower rail.
The unique sash design tilts and slides parallel to the fixed unit with the touch of a finger.
Do this with a helper.
The added functionality of a tilt slide door allows you to let in fresh air without full exposure to the outside.
Reattach the head stop first otherwise it could fall out.
If the door becomes even harder to open turn the screw in the opposite direction.
After a bit of adjustment the door should roll easily without rubbing on the bottom track.
To remove a bottom supported sliding door lift and then tilt the bottom out of the track.
Then sharply angle the bottom of the door outward and lift the door from the track.
Lift a bottom supported door such as an sliding glass patio door straight up to clear the bottom track.
Align it in the bottom track and then tilt it up.
In that case you only have to lift the door and guide the roller back onto the track.
Step 2 lay the door on a flat surface and tighten the screws in all four corners.
Tilt and slide door repairing.
Fabricated from our system 4500 line this design is a premium door solution for spaces that do not allow for traditional inswing doors.
If an off track roller isn t the problem you ll have to remove the doors to adjust and possibly replace the rollers.