Once it s on the floor push down on the bowl to compress the wax ring.
Toilet bowl on the floor.
Sometimes a rocking toilet can be fixed by tightening the two bolts at the base of the toilet.
Screwdriver sets step 1.
Instead they secure to a toilet flange.
While this is true you should know that the bolts don t go directly to the floor.
Use a scraper to remove the old wax ring from the floor and toilet as well as disinfectant to clean around the area.
Remove and replace the wax ring step 5.
Gather tools and materials step 2.
Remove lift and set the toilet on the floor upside down or on its side.
Check carefully for water around the.
Your wobbly toilet may be moving because the mounting bolts that hold it down have nothing to grab onto anymore.
Remove the toilet and turn it on its side.
Disconnect the water supply line with an appropriate sized wrench.
Remove the nuts from the mounting bolts that hold the tank onto the bowl with a wrench.
Measure the depth and width of the gluing edge of the bowl.
Then make an outline of the toilet on the floor with masking tape.
Hold the toilet upright over the flange and guide the bolts through the holes in the base as you lower it in place.
Water on the floor or a running toilet could signal the need for a minor repair a major one or even a new toilet and a few simple tests can help you decide which it is.
Turn off your home s water supply and begin emptying the water from the toilet bowl and the tank.
The location of the.
Next move your caulk gun to the inset depth you just measured and apply caulk directly to the floor maintaining the inset depth as you follow the tape.
Check the connection bolts and tighten or replace step 3.
Undo the t bolts and lift the toilet off the floor.
There should be one on each side.
Flush the toilet to drain as much as possible and use rags to sop up any water that remains.
Lay a tarp or newspaper down to protect your floors.
Disconnect the toilet step 4.
Start the repair by confirming that your toilet is not leaking.
Unscrew the water line from the tank.
Examine the base of the.
Instructions check the bolts first.
Carefully lift the tank off the bowl and place out of the immediate area then remove the nuts from the floor bolts.
Toilets are sealed to the floor flange with a wax ring but the height of the flange and the tightness of the flange bolts that secure the toilet to the floor can affect the ring s ability to create a watertight seal.
You also want to make sure the toilet sits level and does not rock on the floor as this can compromise the seal.