Locate and remove all old nuts bolts and washers.
Toilet leaking from tank onto floor.
Clean area to remove rust and anything else.
Although this may sound like a tough job it s fairly easy to do as long as you have a helping hand.
Stop water from flowing to the toilet by cutting off the supply via the shutoff valve remove the lid and disconnect the water supply hose and unscrew the bolts lift up the damaged tank and dispose of it properly place the new tank in its place and install all the necessary hardware and.
Most toilets have a wax seal around their base.
Place a bucket underneath your toilet tank to catch any excess water.
To do so you ll need to.
Condensation occurs when the bathroom is warm and humid and the water in the tank is very cold.
Step 3 step 1.
Then flush and hold the lever down to drain the.
Disconnect your water supply line.
Leaks from the toilet base.
5 replacing the spud washer.
If the tank is not securely bolted to the toilet water can leak out around the seal and travel down the sides of the bowl to the floor making it look like the leak is coming from the base.
Remove water line from back of toilet.
Pull the tank.
The first step is to shut off the water supply to your toilet.
When people think of leaky toilets they usually think of water that runs constantly from the tank and into the bowl.
First turn off water.
Loosen the jamb nut that secures the water supply line to the tank.
Dispose of bolts and bad seals.
Flush toilet and sponge out water from tank.
Sometimes the tank can spring a leak and cause water to drip water from it and onto the floor.
Remove the 2 or 3 bolts holding toilet tank to base.
Make sure you have a helper toilet tanks are usually in an awkward place and are heavier than they appear.
To fix a toilet that has the same problem as above.
In extreme cases it can form puddles on the floor and eventually the tank and walls may turn black.
However if your toilet is old you may need a new seal.
Simply tightening the bolts often solves this.
Loosen the nuts that secure the hold down bolts which may require you holding the top of the bolt with a screwdriver.
Lift the tank straight up and off the toilet base and set it upside down on the floor on an old towel or rug.
If the wax seal around the base of your toilet is worn then it s time to change it.